Featured Guide
Latest by date
Safety & Standards
Category articles
Electrical work practices and standards: isolation, verification, arc-flash assessment, PPE and compliance boundaries. These guides explain requirements and their scope; device selection is covered in Protection & Safety and relay schemes in Protection & Control.
-
Earth Electrode Testing: Soil Resistivity, Resistance and BS 7430 Boundaries
Earth-electrode testing begins by identifying the quantity you need: soil resistivity, electrode resistance or impedance to remote earth, bonding continuity, or surface potential during a defined condition. These…
-
Electrical Safety Culture: Turn Hazard Reports into Verified Controls
Electrical safety culture becomes observable when a worker can raise a concern, obtain a controlled response, and see that the corrective action actually works. Build that feedback loop…
-
Temporary Jobsite Power: A U.S. NEC and OSHA Verification Workflow
Temporary jobsite power needs a source-to-use verification record, not just a generator, extension cords and a ground-fault circuit interrupter (GFCI). Define the supply and load duty, verify distribution…
-
ATEX Camera Selection for Zone 1 and Zone 2: Verify the Complete Assembly
An ATEX camera is suitable for a Zone 1 or Zone 2 installation only when the complete installed configuration matches the classified atmosphere and its conformity evidence. Check…
-
Arc-Flash Labels and Operating Modes: A Configuration-Check Workflow
An arc-flash label is useful only when its information applies to the equipment and operating conditions under review. Trace it to the equipment identity, study revision, credible supply…
-
UL Terminal Blocks for U.S. Equipment: A Compliance Selection Checklist
A UL Recognized terminal block is a component evaluated for use inside a larger end product under stated conditions. It does not, by itself, make an industrial control…
-
Insulation Resistance Testing: Principles, Procedure and Interpretation
Insulation resistance testing applies a controlled DC test voltage to de-energized insulation and measures the small current that flows. The instrument reports resistance, usually in megohms or gigohms.…
-
Code Q&A: Lighting Outlet Requirements
There is no single worldwide answer to “How many lighting outlets are required?” The answer depends on the adopted electrical code, local amendments, occupancy, room use, location conditions,…
-
ATEX Lighting Zones for Hazardous Areas: A Practical Selection Guide
ATEX lighting selection starts with the area classification and the substance hazard—not with a luminaire catalogue. A compliant decision normally needs the classified zone, the gas/vapour/mist or dust…
-
How to Choose the Right Arc Flash PPE
Choose arc flash personal protective equipment (PPE) from a documented hazard assessment, not from system voltage alone. The decision should connect the task, the equipment condition, the incident…